Orders / Commandes (450) 449-4442
The stock availability is a live feed system. If item is not in stock, we will order it as fast as possible for you.
Some items are Special Order Only. We don't carry them in stock. Call us to place an order.
Check StockRemoves rust and scale from high mileage or older cooling systems in preparation for the installation of Evans Waterless Coolant.
1. Determine cooling system capacity (refer to owner's manual).
2. * When the engine is cool, remove the cap, open draincock, and drain cooling
system (remove block drains if applicable). Collect used antifreeze
for disposal. When disposing of used antifreeze/flush, please follow local laws and regulations.
3. Flush with water until water runs clear.
4. Close all drains.
5. Install flush (refer to chart).
6. Once the appropriate amount of flush is installed into the
radiator, fill the system with water.
7. Place heater on the highest setting.
8. Drive vehicle for 2 hours at normal temperature. DO NOT let sit
idling, MUST drive!
9. Allow the engine to cool to room temperature. NEVER WORK on a HOT system!
10. Drain system. * * Remove block drains if applicable, drain
radiator and heater core.
11. Flush with water until it runs clear. This will neutralize the flush.
12. Start the installation process to convert to Evans Waterless
Coolant by following the
standard Evans installations.
Note* It is essential that you adhere to the dosage recommendation
chart as overdosing of the flush is not recommended and could cause harm
to your cooling system.
WARNING: Reproductive Harm
System Capacity Evans Flush
(gallons) (ounces)
1 16oz.
2 32oz.
3 48oz.
4 64oz.
5 80oz.
6 96oz.
7 112oz.
8 128oz.
9 144oz.
10 160oz.
